Brady 300X-PLUS Bedienungsanleitung PDF herunterladen (Seite 26)

20 User Manual Edition 04/10

BP-PR PLUS Series

Table 9. Parameters of the menu Setup > Print param.

Parameter Meaning Default

Backfeed

Method for backfeeding the label medium. Backfeeding is

necessary in the cutting and peel-off modes since a label is

pushed out passed the front edge of the next label above the print

line when peeling off/cutting. always: Backfeeding occurs

independently of label contents. smart: Backfeeding only occurs

when the next label is not yet fully prepared when peeling off/

cutting the current label. Otherwise, the second label is pushed on

and completed after removal of the first label without backfeeding.

smart

Error-Reprint

On: With a correctable error and corresponding troubleshooting,

the label being printed when the error occurs is repeated. Off: Print

job is continued with the next label.

Pause reprint

Printing of another label with the information of the previous print

job by pressing the pause button. This function can be executed

until the print buffer is cleared with the cancel button.

Off

Protocol error

On: Printer switches to Error mode when unknown or faulty data is

received. Off: When working with older computer operating

systems, it is possible that the print spooler of the operating

system will reply to the printer with normal status messages of the

printer (e.g. end of paper) in the form of ASCII text. The printer

cannot interpret this data and outputs a large number of protocol

errors. In this case, it is advantageous if you set the Protocol

error parameter to Off. Caution: If the Protocol error parameter

is set to Off, protocol errors which can be traced back to faulty

programming are also ignored. There is a risk of data loss.

Barcode error

On: With faulty barcode contents or size specifications, printing is

interrupted. Off: Printing is not interrupted if an error occurs. If

barcode contents are faulty, the printer attempts to replace the

incorrect data with valid characters (e.g. zeros). If barcode size

specifications are faulty, a gray area is printed instead of the

barcode.

Width ASCII

dump

Width of printing area in the "Monitor mode" test function (see 5-6

ASCII Dump Mode on page 40). With the Automatic setting, the

printout of the control sequences arriving at the printer occurs over

the maximum printing width. You can reduce the printing area

width down to 50 mm.

Automatic

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 66 67

Kommentare zu diesen Handbüchern

Keine Kommentare

Brady 300X-PLUS Bedienungsanleitung Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucken & Scannen Brady 300X-PLUS