Brady THT-BP Precision Spezifikationen PDF herunterladen (Seite 6)

6 THT-BP Precision

Loading Labels

Figure 2

The following steps are valid for loading labels in tear-off mode.

Instructions for loading labels in rewind or dispense mode and for loading

fanfold labels can be found in the Printer's Operator Manual or in the

documentation of the Present Sensor.

1. Loosen the knurled screw (3), swing the media retainer (4) upwards and

slide it out as far as possible.

2. Place the media roll (5) onto the media hub (6) and unwind a strip of

media from the media roll. Make sure the labels are facing up. Slide the

roll onto the media hub (6) until its stops.

3. Swing the media retainer (4) downwards until it touches the media hub (6).

Push the media retainer against the supply role until it rests against the

label media. Tighten the knurled screw (3).

4. Raise the printhead assembly (1) by rotating the lever (2) clockwise until it

stops.

5. Slide the media guide ring (7) outward, allowing enough clearance for the

label stock's width when loaded.

6. Slide the media strip through the printer as shown in figure 2. The feed

path for labels wound-out is represented by a solid line, and the feed path

for wound-in labels is represented by a broken line.

7. Move the label edge sensor assembly (8) in such a position that the

sensor (9) itself can detect label gaps, notches or reflective marks.

The adjustment of the sensor is performed by sliding the handle (10) in

and out.

1 2 3 4 5

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Keine Kommentare

Brady THT-BP Precision Spezifikationen Seite 6