Brady THT-BP Precision Betreibershandbuch PDF herunterladen (Seite 117)

D-3Transfer Printer THT-BP Precision

During operation of the printer, paper dust can accumulate on the label edge

sensor. In some cases, this may lead to problems when sensing the media.

If this is the case, you should clean the label edge sensor.

CAUTION !

Do not use solvents to clean the label edge sensor!

Do not use sharp objects to clean the optical sensor!

1. Remove the media from the printer.

2. Press the latch (1) in the direction of the arrow in figure D-1.

3. Continue pressing the latch and pull the label edge sensor (2) with the

handle (4) to its outermost position.

CAUTION !

The label edge sensor cannot be removed totally ! There is a stop when

the label edge sensor reaches the outermost position ! If you try to pull

further the label edge sensor can be damaged !

4. Clean the label edge sensor and its optical sensors (3) with a soft brush or

a cloth dipped in isopropyl alcohol.

5. Slide the label edge sensor back into its original position.

Fig. D-1 Cleaning the Label Edge Sensor

Cleaning the Label Edge Sensor

Appendix D - Maintenance / Cleaning

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 131 132

Keine Kommentare

Brady THT-BP Precision Betreibershandbuch Seite 117