Brady PAM 3000 Spezifikationen PDF herunterladen (Seite 15)

15Printer-Applicator-System PAM 3000

Setup

Using the setup mode, the configuration of the PAM 3000 may be customized to suit

specific requirements. Initial setup should be performed when operating the printer for

the first time. Changes which become necessary to process different print jobs, e.g.

when different materials are used, can mostly be accomplished by changing the software

settings.

Start of Setup Mode

This mode is initiated by either simultaneously pressing the key and the

key when switching on the printer and keep them pressed down until the system test is

completed, or in ONLINE mode, press the same two keys down for at least 5 seconds.

Each time a parameter setting has been changed, there will be a request for

confirmation. There will not be a general request before leaving the setup mode.

Leaving the Setup Mode

The setup mode can be left at any point by pressing the key. The confirmed

parameters will be saved.

If an already confirmed setting is not desired any more, switch off the printer during the

setup mode to cancel changes.

Restore the Default Setup

To return to the original factory default settings, press all three keys, the key,

the key, and the key simultaneously and keep them pressed down until the

display shows "--- RESTORE ---".

ONL key Stores the chosen settings of the setup parameters and

completes the SETUP mode.

(i.e. switch into ONLINE mode/ LED ONL on)

FF key Skips to next setup parameter.

Reduces numerical setup values.

CAN key Skips to previous setup parameter.

Increases numerical setup values.

PSE key Confirms selected settings for parameters.

Function of the Keys in the Setup Mode

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Brady PAM 3000 Spezifikationen Seite 15