Brady TLS2200 Bedienungsanleitung PDF herunterladen (Seite 24)

TLS PC Link

Programmer’s Guide

Set Printer to Inches (STX n)

This command sets the printer to interpret measurements in inches in terms of

in./100, (e.g., <STX>M0500 will be interpreted as 5.00in.). See STX m.

Sample:

<STX>n

Default setting: Inches

Feedback possibilities: 0,1,2

Set Start of Print Offset (STX O)

This command sets the point where printing starts, relative to the top-of-form

position. Top-of-form is the point where a label edge is detected by the label

edge sensor. The printer will feed from the top-of-form to the offset point

specified in this command, and begin printing there. This offset value is

independent of the STX f, set form stop position command.

<STX>Osnn

Where:

s- sign of offset, ‘+’ or ‘-’

nn- two digit value of offset

The valid range is -05 to +99.

Sample:

<STX>O+05

The above sample sets a start of print position of 5 pixels after the default

position.

Feedback possibilities: 0,1,2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Keine Kommentare

Brady TLS2200 Bedienungsanleitung Seite 24